Description :
Capacity(L) | Working pressure(bar) | Paint output | Dimension(mm) | Inner height(mm) | Inner paint Dia(mm) |
10 | 1.4-2.0 | 1/4 | 259*246*465 | 208 | 234 |
Capacity(L) | Working pressure(bar) | Paint output | Dimension(mm) | Inner height(mm) | Inner paint Dia(mm) |
10 | 1.4-2.0 | 1/4 | 259*246*465 | 208 | 234 |
Feature Description :
1.Big capacity tank perfect for big area spraying liake in/out wall,floor,machinery etc.
2.Power coating processing tank.
3.One-piece format tank.
4.Paint outlet:1/4".3/8".
5.Mounted on wheels,on/off air ball valve.
6.Pickup tube has filter screen.
7.Large lid clas&gasket that will not fall off during lid removal.
Air Tools Trouble Shooting:
Air tools runs at normal speed, but loses under load | Motor parts worn Cam cluth worn or sticking due to lack oflubricant | Lubricating clutch housing. Check for excess clutch oil. Clutch cases need only be half full Overfilling Can cause drag on high speed clutch parts,is a typical oiled/lubricated wrench requires 1/2 ounce of oil |
Air tools runs slowly, Air flows slightly from exhaust | Air tools's motor parts jammed with dirt particles Power regulator in closed position Air flow blocked by birt | Check air inlet filter for blockage. Pour air tools lubricating oil into air inlet as per instructions. Operate tool in short bursts quickly reversing rotation back and forth where applicable.Repeat above as needed.Air |
Air tools will not run, Air flows freely from exhaust | One or more air tools's motor vance stuck due to material build up | Pour air tools lubricating tool into air inlet Operate tool in short bursts of forward and/or reverse rotation where applicable Tap motor housing gently with plastic mallet Disconnect supply. Free motor by rotating drive shank manually where applicable |
Air tools will not shut off | Air tools's "O" rings throttle valve dislodged from seat inlet valve | Replace air tools's"O" ring
|
Showroom